Centroid 13126, Install Manual

Page: 51 / 86

6.5 S
PINDLE
S
ETUP
From Main Screen Setup (F1) → Config (F3) (Default Password = 137) → Contrl (F1)
The Control Configuration screen provides you with a method of changing controller dependent data.
If you wish to change a field, use the up and down arrow keys to move the cursor to the desired field. Type the new value and
press <ENTER>. When you are done editing, press <F10> to save any changes you have made. If you wish to discard your
changes and restore the previous values, press <ESC>.
Maximum Spindle Speed (High Range)
This field sets the high range maximum spindle speed for those machines that have a variable frequency spindle drive (VFD). All
spindle speeds entered in a CNC program are output to the PLC as percentages of this maximum value.
If your machine is equipped with a dual range spindle, see the Parameters 65-67 section below.
Minimum Spindle Speed (High Range)
This parameter sets the minimum spindle speed when in high range. If minimum spindle speed is set to a value greater than zero,
the spindle voltage will output the minimum voltage equivalent until the commanded spindle speed is greater than the minimum