Centroid 13126, Install Manual

Page: 32 / 86

Common Wiring Problems:
The following information is also covered in Technical Bulletin 78 which can be found here:
(
http://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/78.pdf )
Page 32 of 86 Chapter 5 Electrical Cabinet Wiring
Figure 5.1.2
Common Wiring Problems
The Wire is too small
for the spade terminal
Red = 18-22 ga.
Blue = 14-16 ga.
The Wire is too
large for the spade
terminal
Do not cut
strands away
These are for
cutting wires, not
stripping.
This type of tool is used
for stripping wires.
When cutting back the insulation on a
cable, do not cut the insulation on the
wires inside the cable.
These are cuts in these
wires from careless
stripping of cable. This is
very bad.
Some strands are cut
because a cutter was used
to strip.
A cutter cannot be
used to strip wires.
Wrong Crimp
Terminal
Wrong Crimp
Terminal
22 ga
12 ga