Centroid 13126, Install Manual

Page: 24 / 86

4. Control Configuration:
From the main screen press F1 Setup → F3 Config. The password is 137 . Press F1 Contrl.
1) Set the units of the machine, change both DRO display units and Machine units to either Inches or Millimeters with
space bar.
2) Set Max Spindle speed to 3000 and Min Spindle to 0 .
3) Change Machine home at power up to Jog with the space bar.
Press F10 Save.
5. If no Jog Panel is being used disable it: This step is only required if you do not have a Jog Panel. If you have a Jog
Panel or Pendant, connect it and continue to step 5.
Select Jog Panel Required in the Control Configuration and press the space bar to change to No .
Press F10 Save .
Page 24 of 86 Chapter 4 Configuring for a Bench Test
Figure 4.1.3
Changing machine home at powerup
Figure 4.1.4
Disabling jog panel