Revision 1.3a
Page 16
XLR 550 Manual
SECTION 3
WEB INTERFACE ONE THE XLR 550
3.0.
Before Starting
The web interface allows an easy to use GUI to be used to monitor and configure the XLR.
However there are some configuration options which are not available by the web interface and
which must be accessed by the CLI
Before you’re able to connect to the XLR web interface its necessary to know the IP address of
the unit. By default the IP address is
192.168.42.20 with a sub network mask of 255.255.255.0.
However you can change this address using the Command line Interface. To change the IP
address undertake the following steps
Connect your PC to the console port
The data rate maybe 9600, 19200 or 38400, the default rate is 38400bps
Hit carriage return a few time and you will receive the prompt. The Table below provides
instruction on how to change the IP address from the CLI.
The symbol ^ indicates a space
Prompt from XLR
Enter
Action
Carriage Return
(wake up manager)
Enter password
password
(logs you in as a user)
XLR554>
en
Move to admin mode
Enter password
password
XLR554>enable
Now logged on as admin
Set^int^m1^ip^192.168.42.20^255.255.255.0 Sets IP Address
Wr^config0
Write change to config 0
Re^sys
Resets the system to load
change
This command will
reboot system. Do you
want to continue (y/n)
y
Reboots the XLR
exit
Exit from CLI manager
Show?
Displays the commands
available