Revision 1.3a
Page 7
2.7.3.
2BASE-TL PME Status LEDs
2.7.4.
For each 2BASE-TL PME, the XLR 500 has LEDs showing the status as shown in figure 2-5.
2.7.5.
The number attached nearby to the LED is the PME number.
Table 2-5 below describes the LED’s functions.
Table 2-5
LED State
Description
Off
Data Link Down or Hand Shaking
Slow Blinking
Training
Fast Blinking
Synchronizing
On
Data Link Up
2.8.
Installing The XLR 500
This section described how to install the XLR 500. User may be aware of the safety information
in order to assure users’ safety and the XLR 500’ optimum performance. Where special
attention is required a safety symbol is shown.
2.1.
Checking the items shipped
The following hardware items are needed, in addition to main device for installation.
For XLR 5xxA
- AC power cable
- UTP cable with RJ-45 for LAN connection
- UTP cable with RJ-45 connector for 2BASE-TL connection
- Console cable ( RJ-45 male to DB-9 female )
For XLR 5xx :
- DC adapter ( 5V DC 3A )
- UTP cable with RJ-45 for LAN connection
- UTP cable with RJ-45 connector for 2BASE-TL connection
- Console cable ( RJ-45 male to DB-9 female )
Above items are shown in figure 3-1.
< Figure 2-5 > LEDs for Each PME