Revision 1.3a
Page 12
On power up of the XLR, if the console is connected correctly and the unit is powering up
correctly the users should see the XLR going through the boot up process.
After the boot up process has completed the message , “Enter password” will appear. (If the
booting process of the equipment has completed before console connection, users may miss
the boot messages. In this case, simply input
ENTER
key into the terminal program and user
should be able to see a message saying “Enter password”)
Users should type the password to log into the system. (password is preliminarily set as
“password”; but users may change the password - refer to the CLI manual)
User may configure the system with the instruction set provided in the CLI manual.
NOTE
: This
H/W installation guide
includes 2BASE-TL port connection and verifying its
function. Therefore, some basic 2BASE-TL port setting commands are provided here:
< Table 4-1 > Configuring Mode of 2BASE-TL Port
Operation on XLR 55x
Command input
Setting XLR 500 series as CO mode
set devicetype co
Setting XLR 500 series as RT mode
set devicetype rt
2.15
Troubleshooting the XLR 500.
This section covers troubleshooting on the XLR 500. If the problem is beyond the scope of this
document, you may request Technical Assistance from our technical support team. (see
Appendix B for Technical Assistance)
Table 5-1 below provides troubleshooting procedures, and figure 5-1 describes status LEDs.
< Figure 5-1 > Description of Status LEDs
Power
Status
Ethernet Port
Status
Data Rate
Full half Duplex
DSL Line Status
Handshaking
Sync
Reset
Button