Carver 33 SUPER SPORT, Owner'S Manual

Page: 45 / 164

3327 12/04
DC E
LECTRICAL
S
YSTEM
S
ECTION
2
2.2.1.8 Main - One
This breaker protects the circuitry between the DC Control Center and
the “house” battery. This breaker must be “ON” to provide power to the
DC Control Center.
2.2.1.9 Main - Two
This breaker helps protect the circuitry between the Bridge Breaker
Panel and the “house” battery. This breaker must be “ON” to provide
power to the Bridge Breaker Panel.
2.2.1.10 Windlass
This breaker controls the flow of electricity to the controls that operate the
windlass. A set of windlass controls are located both at the helm and on the
fore deck. To supply power to the controls, switch this breaker “ON.” Refer
to the OEM information for details on operating the windlass.
NOTE: The windlass circuit also contains an in-line fuse that protects
the windlass switch solenoid. This fuse is located in the anchor chain
locker.
2.2.2 DC Control Center
The DC Control Center, located in a cabinet next to the forward end of
the salon sofa, manages the power supply to most of the boat’s 12-volt
equipment, except for the equipment on the bridge.
To provide power to this breaker panel, turn the “house” battery master
disconnect switch to the “ON” position.
The DC Control Center contains the switches and circuit breakers de-
scribed below.
2.2.2.1 Bilge Blower
Use this switch to operate the bilge blowers. To activate this switch, first
switch the two Bilge Blower circuit breakers “ON.”
2.2.2.2 Generator
Use this switch to start and stop the generator. Refer to the OEM infor-
mation for details on operating the generator.
2.2.2.3 Main
This breaker controls the flow of electricity to all of the other circuit
breakers on this panel. To supply power to the other circuit breakers,
switch the Main breaker “ON.”