Carver 33 SUPER SPORT, Owner'S Manual

Page: 89 / 164

3327 12/04
I
NTERNAL
S
YSTEMS
S
ECTION
4
6. Replace the “WASTE” deck plate.
A Tip From Carver!
The WASTE deck plate is not connected to the fitting and does not float. Be
careful that you don’t drop the plate in the water when you remove it.
If you do lose the plate, you can order a replacement from your Carver Dealer.
WASTE deck plates are dropped overboard frequently enough that we suggest
you carry an extra in your onboard spare parts kit.
4.5.2.2 Overboard Discharge
NOTE: It is against the law to discharge waste overboard in many areas
of the United States. It is your responsibility to make sure that you are in
compliance with all applicable federal, state and local laws when using
your boat’s overboard discharge system. People who discharge waste
overboard in restricted areas are subject to significant penalties.
In certain coastal areas of the world it is legal to discharge the waste
from your boat’s waste tank into the sea. To accommodate this procedure
Carver offers an optional overboard discharge system for your boat. This
system is available only on boats that are exported or used in the coastal
areas of the United States.
With the overboard discharge system, waste is flushed from the toilet to
the waste tank where it is stored. Where it is legal, you can then empty
the waste tank directly overboard. If overboard discharge is not legal
where you are, you can either wait until you reach an area where it is
legal or use a dockside pumpout station to empty the waste tank.
To empty the tank:
1. Open the overboard discharge seacock. The seacock is located be-
neath a hatch in the companionway outside the head. Refer to 9.7.1
Hatches for the exact location of the seacock.
2. If your boat has the optional grey water holding system, turn the Y-
valve to select the waste tank. The Y-valve is located next to the
overboard discharge seacock. Otherwise, proceed to step 3.
3. On the Safety Breaker Panel:
a. Turn the “house” battery master disconnect switch to the “ON”
position.
b. Switch the Main - One circuit breaker “ON.”
Open Closed