Carver 33 SUPER SPORT, Owner'S Manual

Page: 57 / 164

3327 12/04
AC E
LECTRICAL
S
YSTEM
S
ECTION
3
5. Locate your 50' shore power cord(s).
Do not allow the end of the shore power cord(s) to hang in the water.
This can cause an electrical field to form which can kill or seriously injure
nearby swimmers or passengers.
6. Connect the female end of the cord(s) to the boat’s shore power
receptacle(s). The receptacles are located in the cockpit in the port
aft locker.
7. Secure the nonmetallic threaded locking ring that locks each cord to
the boat’s shore power receptacle. This prevents the cord(s) from
being accidentally disconnected and from arcing due to a gap be-
tween the cord plug and the receptacle.
8. Choose a neat and safe way to route the shore power cord(s) to the
shore power source box.
9. Switch the circuit breaker that is installed in the shore power source
box “OFF.”
10. Plug the male end of the shore power cord(s) into the shore power
source outlet.
11. Secure the nonmetallic threaded locking ring that locks each cord to
the shore power source outlet. This prevents the cord(s) from being
accidentally disconnected and from arcing due to a gap between the
cord plug and the outlet.
12. Switch the circuit breaker that is installed in the shore power source
box “ON.”
13. Switch the AC Main circuit breaker group(s) “ON.”
14. There are Polarity indicators on the AC Control Center for Shore #1
and Shore #2. If either or both of the Polarity Reverse indicators
illuminate, immediately switch the respective AC Main circuit
breaker group(s) “OFF.”
If you are in Germany or Italy, disconnect the shore power cord
from the shore power source outlet, rotate the cord’s plug 180
degrees, then plug the cord into the outlet again. Repeat steps 11
through 13. If the Reverse Polarity indicator(s) illuminates again,
disconnect the affected shore power cord. Notify marina manage-
ment of the reverse polarity problem and use a different shore
power source box.