Carver 33 SUPER SPORT, Owner'S Manual

Page: 145 / 164

3327 12/04
W
INTERIZATION AND
S
TORAGE
S
ECTION
8
8.3.10 Interior
Air out the cushions and make sure they are dry. Storing damp cushions
leads to mildew. Position the cushions so air can circulate around them.
Purchase and position moisture accumulators throughout the boat. These
help reduce the amount of moisture that accumulates during storage.
Remove everything from the boat that could spoil or freeze while the
boat is stored. Also remove all dried food. Food attracts mice and insects.
To give your boat the maximum protection while it is in storage, Carver
recommends that you place your boat in dry, as opposed to wet, storage.
Protecting the boat from the elements during winter storage is advised.
Have your marina shrink wrap the boat or have a winter storage cover
made. Occasionally check on the boat while it is in storage to make sure
that it is in good condition.
8.4 Storage
8.4.1 Dry Storage
If your boat will be in outside storage, properly support a storage cover
and secure it over the boat. Do not secure the cover to the boat too
tightly. Allow adequate ventilation to protect against dry rot. Do not
store the boat in a damp storage enclosure. Purchase and position mois-
ture accumulators between the shrink-wrap and your boat’s enclosures to
help prevent moisture from accumulating. Excessive dampness can lead
to mildew, electrical problems, corrosion and dry rot.
NOTE: Do not use the bridge enclosure canvas in place of a winter storage
cover. This canvas is not designed for long-term storage purposes. The life
of the enclosure canvas may be significantly shortened if it is exposed to
harsh weather for prolonged periods.
8.4.2 Wet Storage
Wet storage procedures vary from region to region. Consult your Carver
Dealer before preparing to leave your boat in the water over the winter.
8.5 Spring Recommissioning Checklist
Before launching your boat, complete the following.
8.5.1 Hull
❑
Fill gelcoat nicks and gouges
❑ Inspect props, struts, rudders