Carver 33 SUPER SPORT, Owner'S Manual

Page: 90 / 164

I
NTERNAL
S
YSTEMS
3327 12/04
S
ECTION
4
4. On the DC Control Center:
a. Switch the Main circuit breaker “ON.”
b. Switch the Waste Pump circuit breaker “ON.”
5. Turn the overboard discharge pump switch “ON.” The switch is
located near the overboard discharge seacock. Refer to 9.7.1
Hatches for the exact location of the switch. This activates the
overboard discharge pump, which pumps the waste overboard.
When the waste tank is empty, turn the overboard discharge pump switch
“OFF.” Operating the pump when the waste tank is empty can damage
the pump.
6. After all waste is pumped overboard, turn the overboard discharge
pump switch “OFF.”
7. Remove the waste tank deck plate labeled “WASTE” using the re-
moval tool supplied with your boat. This plate is located on the
forward port side deck. Refer to 9.7.2 Deck Plates for the exact
location of this plate.
8. Flush the waste tank by pouring a few gallons of fresh water through
the “WASTE” deck fitting.
9. Reactivate the overboard discharge pump and remove the fresh
water and any remaining waste, then turn the pump “OFF.”
10. Close the overboard discharge seacock.
11. Replace the “WASTE” deck plate.
12. On the DC Control Center, switch the Waste Pump circuit breaker
“OFF.”
4.6 Grey Water Holding System
Certain areas of the United States and Europe have initiated antipollu-
tion regulations that require the use of a grey water holding system on
boats.
When the optional grey water holding system is installed, all sink and
shower drain water, as well as condensation from the air conditioning
unit, drains into a grey water holding system rather than directly over-
board. This system contains two 40-gallon holding tanks that are inter-
connected by a gravity-feed hose so that they function as a single tank.