Carver 33 SUPER SPORT, Owner'S Manual

Page: 92 / 164

I
NTERNAL
S
YSTEMS
3327 12/04
S
ECTION
4
1. Open the overboard discharge seacock. The seacock is located be-
neath a hatch in the companionway outside the head. Refer to 9.7.1
Hatches for the exact location of the seacock.
2. Turn the Y-valve to select the grey water tanks. The Y-valve is
located next to the overboard discharge seacock.
3. On the Safety Breaker Panel:
a. Turn the “house” battery master disconnect switch to the “ON”
position.
b. Switch the Main - One circuit breaker “ON.”
4. On the DC Control Center:
a. Switch the Main circuit breaker “ON.”
b. Switch the Waste Pump circuit breaker “ON.”
5. Turn the overboard discharge pump switch “ON.” The switch is
located near the overboard discharge seacock. Refer to 9.7.1
Hatches for the exact location of the switch. This activates the
overboard discharge pump, which pumps the grey water overboard.
When the grey water tanks are empty, turn the overboard discharge
pump switch “OFF.” Operating the pump when the grey water tanks are
empty can damage the pump.
6. After all grey water is pumped overboard, turn the overboard dis-
charge pump switch “OFF.”
7. Remove the grey water tank deck plate labeled “WASTE” using the
removal tool supplied with your boat. This plate is located on the
forward port side deck. Refer to 9.7.2 Deck Plates for the exact
location of this plate.
8. Flush the grey water tanks by pouring a few gallons of fresh water
through the “WASTE” deck fitting.
9. Reactivate the overboard discharge pump and remove the fresh
water and any remaining grey water, then turn the pump “OFF.”
10. Close the overboard discharge seacock.
11. Replace the “WASTE” deck plate.
12. On the DC Control Center, switch the Waste Pump circuit breaker
“OFF.”
Open Closed