Carver 33 SUPER SPORT, Owner'S Manual

Page: 144 / 164

W
INTERIZATION AND
S
TORAGE
3327 12/04
S
ECTION
8
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s grey water holding system. Using the wrong type of antifreeze can
damage the grey water holding system. The repair of such damage is not
included under the terms of the Carver Limited Warranty.
3. Pour 3 gallons of nontoxic recreational vehicle antifreeze through
the shower and each sink drain.
4. Under the boat, place a large bucket beneath the grey water over-
board discharge fitting to collect antifreeze pumped out later in this
procedure.
5. Open the grey water overboard discharge seacock.
6. Turn the Y-valve to select the grey water tanks.
7. On the DC Control Center:
a. Switch the Main circuit breaker “ON.”
b. Switch the Waste Pump circuit breaker “ON.”
8. Turn the overboard discharge pump switch “ON.”
9. When a steady stream of antifreeze flows from the overboard dis-
charge fitting, turn the overboard discharge pump switch “OFF.”
10. Close the overboard discharge seacock.
11. Switch the Waste Pump circuit breaker “OFF.”
12. When you remove your boat from storage and prepare to use it again,
flush and pump out the grey water tanks to remove the antifreeze.
8.3.9 Exterior
Wash the exterior of the boat, particularly the underwater portions.
Remove as much aquatic growth as possible while it is still wet. Once the
growth has dried it is more difficult to remove.
Check the zinc sacrificial anodes for deterioration. If the zincs show signs
of deterioration have them replaced before spring launch. Check stain-
less steel rails and fittings for signs of rust. Remove rust prior to winter
lay-up. Inspect the underwater portions of the hull. Review anything that
looks out of the ordinary with your Carver Dealer.
Open Closed