Carver 33 SUPER SPORT, Owner'S Manual

Page: 138 / 164

W
INTERIZATION AND
S
TORAGE
3327 12/04
S
ECTION
8
step. Refer to 9.7.3 Thru-Hull Fittings for the exact location of
these fittings.
5. Open the galley sink cold water faucet. When a steady stream of
antifreeze flows from the tap, close the faucet. Repeat this step for
the galley hot water faucet, then for each cold and hot water faucet
on the boat, except for the optional cockpit hand shower and cockpit
fresh water washdown.
For the cockpit hand shower, place the shower head in a bucket
before turning on the shower faucet. This catches the antifreeze,
which can be reused. Proceed as described earlier in this step.
For the cockpit fresh water washdown:
a. Remove the hose from the fresh water washdown fitting.
b. Place a bucket under the washdown fitting to catch the antifreeze,
which can be reused.
c. Open the washdown faucet. When a steady stream of antifreeze
flows from the fitting, close the faucet.
6. If your boat does not have the optional grey water holding system,
pour one quart of antifreeze into the shower and each sink drain.
Otherwise, refer to 8.3.8 Grey Water Holding System to winterize
the shower and sink drains.
8.3.4.3 Preparing the System for Use Again
When you remove your boat from storage and prepare to use it again,
flush the entire fresh water system with fresh water. Nontoxic antifreeze
is colored, so the water system is adequately flushed when uncolored
water flows from all of the faucets and shower heads. You may need to
fill the water tank more than once to flush the system.
8.3.5 Raw Water Washdown
Before performing this procedure on the optional transom raw water
washdown, your boat should be pulled from the water.
Refer to 4.3 Raw Water Washdown for a description of your boat’s raw
water washdown system.
1. Close the seacock that supplies the raw water washdown pump with
seawater.
2. Disconnect the end of the hose that is attached to the washdown side
of the seacock.
Open Closed