Carver 33 SUPER SPORT, Owner'S Manual

Page: 87 / 164

3327 12/04
I
NTERNAL
S
YSTEMS
S
ECTION
4
2. On the Safety Breaker Panel:
a. Turn the “house” battery master disconnect switch to the “ON”
position.
b. Switch the Main - One circuit breaker “ON.”
3. On the DC Control Center:
a. Switch the Main circuit breaker “ON.”
b. Switch the Electric Head circuit breaker “ON.”
4. Use the control switches mounted on the bulkhead next to the toilet
to flush the toilet.
4.5.2 Emptying the Waste Tank
The sanitation system contains one polyethylene waste tank. The tank is
located beneath a hatch in the companionway outside the head. Refer to
9.7.1 Hatches for the exact location of the tank. The two methods of
disposing of waste are described below. Use waste tank deodorizer inside
the waste tank between pumpouts.
4.5.2.1 Dockside Discharge
With the dockside discharge method, waste is flushed from the toilet to
the waste tank where it is stored until it can be transferred to a dockside
pumpout station. To empty the tank:
1. Locate a dockside pumpout station.
2. Remove the waste tank deck plate labeled “WASTE” using the re-
moval tool supplied with your boat. This plate is located on the
forward port side deck. Refer to 9.7.2 Deck Plates for the exact
location of this plate.
3. Attach the pumpout vacuum hose to the “WASTE” deck fitting.
Because the transfer process uses a vacuum action, there must be a
secure connection between the transfer hose and the deck fitting.
4. Activate the pumpout vacuum. The pumpout vacuum transfers
onboard waste to the dockside holding station.
5. After all waste is removed, flush the waste tank by pouring a few
gallons of fresh water through the “WASTE” deck fitting. Reat-
tach the vacuum hose to the deck fitting and activate the
pumpout vacuum again to remove the fresh water and any re-
maining waste.