Carroll Spirit, User Instruction Manual, Page: 5 / 110

Spirit™ Bed Owner’s Manual – 1-70-001 – Rev D © Carroll Hospital Group Inc. Page 5 of 110
Spirit Select™ Bed – Quick Reference Guide
A: Basic Bed Operation
Bed Operation: Use footboard or rail controls to raise/lower head section, knee section, or the entire
bed.
One-Touch CPR: Press and release to automatically flatten head and knee in emergency
Trendelenburg: Push and hold TREND or rev.TREND button to achieve function; to level bed, press
and hold opposite function until bed automatically stops at level.
Chair: Push and hold CHAIR button until bed stops in chair position; push and hold to remove chair
(bed will reverse position each time the CHAIR button is pressed).
Auto Contour: Press CONTOUR button. Illuminated button indicates that the Auto Contour function
is active. Knee section will automatically raise when head section is raised (NOTE: knee lock-out will
override Auto Contour).
Level All: Push and hold to flatten head and knee sections
Lock-Outs: To restrict patient use, press the LOCK button under each function; if the LOCK button is
illuminated, patient control of that particular function with the side rail controls or pendant is
restricted.
If the LOCK button is not illuminated, then patient control of that function is
permitted.
Master Lock-Out: To restrict all side rail, pendant,
and
footboard controls, press all three LOCK
buttons simultaneously (the buttons will sequentially flash). When Master Lock-Out has been
activated, the emergency CPR function and Nurse Call remains enabled.
B: Bed Exit Alarm
1. Place patient in bed
2. Press SET/RESET button to cycle through the sensitivity levels; stop at appropriate level
3. An audible “chirp” will also sound to indicate that the alarm has been armed.
4. Press CHIME button to cycle the through the volume and nurse call levels; stop at appropriate
level
5. A ringing alarm can be silenced by:
• Pressing SET/RESET button (this will shut down alarm mode; once patient is properly
positioned again, you must press SET/RESET to arm); or
• Returning patient to proper position; the “chirp” will indicate the alarm is re-activated
C: Underbed Light
Press LIGHT button to scroll through brightness levels of underbed light (OFF – LOW – HIGH)
Bed Exit Light: Automatically illuminates when patient exits bed. Automatically turns off when
patient re-enters the bed or after 15 minutes has elapsed
E
A
D
C
B