pCOWeb
+030220966 – rel. 1.1 – 12.12.2017
53
When the verbose pop up os open, selecting the notification test, it is possible to set off the transmission of configured emails and check the log of the
communication between
pCOWeb
and the e-mail server as shown on the right.
Figure 9.z - Mail logs
Whe the test is complete, click again the ‘Toggle verbose e-mail output’ to return to standard functionality, as shown below
Figure 9.aa - Exiting from verbose e-mail output
NOTE:
pCOWeb
do not need to be restarted when finishes to monitor traffic.
9.10
RESTARTING
pCOWeb
Some settings require the
pCOWeb
to be rebooted. The reboot can be performed in one of the following ways:
•
Disconnect the power supply for a few seconds (the LEDs must go off), then reconnect (if the operation is to be performed after setting the value of
a parameter, wait until the setting has been confirmed, to allow time for the confirmation to be sent via the browser to
pCOWeb
);
•
or alternatively: select the “Reboot” button available on the configuration web pages (
Figure 9.d
on page 43);
•
or alternatively: use the button shown in
Figure 1.b
on page 8 with the procedure described in 9.10.1.
9.10.1
Restarting
pCOWeb
using the button
PROCEDURE
1.
Check that the Status LED is flashing continuously green or red; in any other situation, the procedure cannot be started.
2.
Select and hold the button for at least 5 seconds, then release it.
IMPORTANT:
pCOWeb
ignores the button when pressed for more than 10 seconds, interpreting this as accidental.
After a few seconds, the Status LED stops flashing, it may change colour and switch off, then it will flash very quickly red-green-red-green for a few seconds,
confirming the reboot; after 1 minute, the completion of the reboot phase will be signalled by the regular flashing of the Status LED.
