Canworld CDE500 Series, Manual

Page: 230 / 284

CDE500 Vector Control AC Drive Chapter 6 Parameters Description
protection
threshold
If the motor temperature( A0.59 ) exceeds the value of motor overheat
protection threshold, the AC drive reports an alarm and performs
protecting action according to F0.20(Ten's digit ).
F0.14 Range: 0.0~200.0 Default: 100.0
Motor overheat
warning
threshold
Unit:
℃
If the motor temperature exceeds the value of motor overheat warning
threshold, the DO terminal allocated with function 18 (Motor overheat
warning) will output ON signal.
F0.15 Range: 0.0~50.0 Default: 20.0
Over-speed
detection value
Unit: %
This function is valid only when the AC drive runs in the VC mode.
F0.16 Range: 0.0~60.0 Default: 5.0
Over-speed
detection time
Unit: Sec
If the over-speed detection time is 0.0s, the over-speed detection function
is disabled.
F0.17 Range: 0.0~50.0 Default: 20.0
Detection value
of too large
speed deviation
Unit: %
This function is valid only when the AC drive runs in the VC mode.
F0.18 Range: 0.0~60.0 Default: 1.0
Detection time of
too large speed
deviation
Unit: Sec
If Detection time of too large speed deviation is 0.0s, this function is
disabled.
F0.19 Range: 0000~2222 Default: 0000
Fault protection
action selection 1
Unit's digit: Power input phase loss
0: Coast to stop
1: Stop according to the stop mode
2: Continue to run
Ten's digit: Power output phase loss
Same as unit's digit
Hundred's digit: Drive overload
Same as unit's digit
Thousand's digit: Motor overload
Same as unit's digit
F0.20 Range: 0000~2222 Default: 0000
Fault protection
action selection 2
Unit's digit: Under load
0: Coast to stop