Canworld CDE500 Series, Manual

Page: 136 / 284

CDE500 Vector Control AC Drive Chapter 6 Parameters Description
Setting Function Description
30 Motor 1/2 swtichover
The configuration of this function can select the current load motor. When
the terminal is invalid, select the motor 1;When the terminal is valid, select
the motor 2.
31
Pulse input(enabled
only for X6/FI) Only X6 terminal effective.When X6 selects this function, the pulse signal
can be received act as the given frequency or count.
32
Command source
switchover terminal 1
When the setting of b0.11 (command source selection) is effective, through
the configuration of these two functions, can realize the switching between
different command source.
Such as X1 selects the “command source switching terminal 1” and X2
selects the “command source switching terminal 2”. So:
 When X1 and X2 has the same state, the command source is the value
of b0.11
 When the X1 is valid and X2 is invalid, the command source is the next
setpoint of b0.11
 When the X1 is invalid and X2 is valid, the command source is the
previous setpoint of b0.11
 The range of b0.11 is 0~2, the next of 0 is 1, the previous of 0 is 2;the
next of 1 is 2 and the previous of 1 is 0; the next of 2 is 0, the previous of
2 is 1.
Table 6- 4 The truth table of command source switch terminals 1/2
b0.11 Setpoint
Command
source switch
terminal 2
Command
source switch
terminal 1
Actual invalid
command source
0 （ Keypad control ） OFF OFF Keypad control
0 （ Keypad control ） OFF ON Terminal control
0
（
Keypad control
）
ON OFF
Communication
control
0
（
Keypad control
）
ON ON Keypad control
1
（
Terminal control
）
OFF OFF Terminal control
1
（
Terminal control
）
OFF ON
Communication
control
1 （ Terminal control ） ON OFF Keypad control
1
（
Terminal control
）
ON ON Terminal control
2
（
Communication
control
）
OFF OFF
Communication
control
2 （ Communication
control ）
OFF ON Keypad control
2 （ Communication
control ）
ON OFF Terminal control
2
（
Communication
control
）
ON ON
Communication
control
33
Command source
switchover terminal 2