Canworld CDE500 Series, Manual

Page: 103 / 284

CDE500 Vector Control AC Drive Chapter 5 Parameter List Table
-90-
Function
Code Name Range Default Step Description
F0.20 Fault protection action selection 2 0000~2222 0000 1
Unit's digit: motor underload
0: Coasting stop
1: Stop by stop mode 2: Jump to 8% motor rated frequency, resume to
setting frequency when underload is inactive.
Ten's digit: Motor overheat （ same as F0.19 unit's digit ）
Hundred's digit: external fault （ same as F0.19 unit's digit ）
Thousand's digit: RS485 communication fault （ same as F0.19 unit's digit ）
F0.21 Fault protection action selection 3 0000~2222 0000 1
Unit's digit: Optional card communication fault （ same as F0.19 unit's digit ）
Ten's digit: PID feedback over limit （ same as F0.19 unit's digit ）
Hundred's digit: Accumulated power on time reached fault （ same as F0.19 unit's digit ）
Thousand's digit: Accumulated running time reached fault （ same as F0.19 unit's digit ）
F0.22 Fault protection action selection 4 0000~2222 0000 1
Unit's digit: Too large speed deviation （ same as unit's digit ）
Ten's digit: motor over speed （ same as unit's digit ）
Hundred's digit: flux postion detection failt
（
same as unit's digit
）
Thousand's digit: UVW signals feedback fault
（
same as unit's digit
）
F0.23 Fault protection action selection 5 0000~2222 0000 1
Unit's digit: Encoder fault
0: Coasting stop
1: Switchover to V/f, and stop by stop mode 2: Swtichover to V/f, and continue running
Ten's digit: User-defined fault 1 （ same as unit's digit ）
Hundred's digit: User-defined fault 2
（
same as unit's digit
）
Thousand's digit: Multi pump interlock fault
（
same as unit's digit
）
F0.24 Frequency selection for continuing
to run upon fault 0~4 0 1
0: Current running frequency
1: Setting frequency
2: Upper limit frequency 3: Lower limit frequency
4: Backup frequency upon abnormality
F0.25 Backup frequency upon abnormality 0.0~100.0 100.0 0.1%
F0.26 Fire mode enable 0~1 0 1 0: Disabled
1: Enabled
F0.27 Fire mode frequency 0.00~b0.00 50.00 0.01Hz
F0.28 Fire mode PID setting increase 0.0~200.0 10.0 0.1%