Canon VB-S30D MKII, Operating Manual

Page: 40 / 185

40
Administrator Password
(1) [Password]
Set the administrator password. Up to eight (single-
byte) ASCII characters (space or printable
characters) can be used. The factory default setting is
“camera”. If the Admin Viewer, Admin Tools, etc., are
connected, terminate the connection before changing
the password.
(2) [Confirm Password]
Enter the same password as above for confirmation.
LAN
(1) [LAN Interface]
Select [Auto], [Full Duplex] or [Half Duplex]. Normally
[Auto] is used.
(2) [Maximum Packet S ize]
Enter the maximum transmission unit. Normally there
is no need to change the default setting of 1500.
Note
When using ADSL, setting the maximum packet size to a slightly
lower value may increase sending efficiency.
IPv4
(1) [IPv4 Address S etting Method]
Select [Manual] or [Auto (DHCP)] in the address
setting method. If [Manual] is selected, directly enter
the values according to the environment in which the
camera is used. If [Auto (DHCP)] is selected, the value
automatically acquired from the DHCP server will be
entered in [IPv4 Address], [Subnet Mask] and [IPv4
Default Gateway Address].
(2) [IPv4 Address]
If [Manual] is specified in (1), enter a fixed IP address.
(3) [ S ubnet Mask]
If [Manual] is specified in (1), enter the designated
subnet mask values for each network.
[Network]
Setting Administrator Password, LAN, IP Address, DNS, etc
The following can be set here.
• Administrator Password
Set the administrator password.
• LAN
Set the IP address and other items needed to
establish a LAN connection.
• IPv4
Set IPv4 address.
• IPv6
Set IPv6 address.
• DN S
Set the name server address, host name and
DDNS registration.
• mDN S
This will configure settings for using multicast
DNS.
• S NMP
Configure the necessary settings to use SNMP.
Important
• To ensure system security, be sure to change the
administrator password. If it is not changed, a message
prompting change of the password will appear continuously
in the upper portion of the Setting Menu. The message will
not disappear until the password is changed. Do not forget
the new password.
• Press the reset switch to restore factory default settings if you
have forgotten the administrator password (p. 167). Note,
however, that this will reset all camera settings to factory
default settings except for date and time.
• [Administrator Password] and [Access Control] >
[Administrator Password] (p. 64) are the same. If you set one
[Administrator Password], the setting will be reflected in the
other [Administrator Password].
Important
• The camera may become inaccessible from the active web
browser if [LAN Interface] or [Maximum Packet Size] settings
are changed. Check beforehand the precautions in
“Important” in “[Reboot Item] Setting Items Requiring
Rebooting” (p. 76).
• Set [Maximum Packet Size] to 1280 or greater if using IPv6.