Canon Finisher-AB1, Service Manual

Page: 441 / 463

Chapter 6
6-2
6.2 Error Codes
6.2.1 Error Codes
T-6-2
Code Detail
code
Occurrence
classification Description Treatment/ detection timing
- Occurrence classification
02: Finisher (including inserter, puncher, trimmer)
11: POD deck 12: Secondary POD deck
51: Stacker 52: Secondary stacker
- When turning ON the power, be sure to turn ON the power in the following order: pickup/delivery accessories ->
Main Body: Otherwise the pickup/delivery accessories are not recognized.
E500 Communication error between main unit and option
0001 02 Malfunction in communication with
ARCNET network Turn power OFF/ ON, re-attach communication
cable/ terminal resistor, replace transceiver PCB.
E501
Communication error between main unit and option
0001 02 Data communication could not be
performed properly and failed after
three retries. Check connections of finisher controller PCB and DC
controller PCB connectors.
- Replace finisher controller PCB.
- Replace DC controller PCB.
E503
Communication error between finisher and options
8004 02 No communication between finisher
and option - Check connections of connectors between finisher
and trimmer.
- Replace finisher controller PCB.
- Possible trimmer problem (For details, refer to the
trimmer manual.)
8005 02 No communication between finisher
and inserter - Check connections of connectors between finisher
and trimmer.
- Replace finisher controller PCB.
- Possible trimmer problem (For details, refer to the
trimmer manual.)
E505 EEPROM error
0001 02 Data malfunction in EEPROM on
finisher controller PCB - Replace the EEPROM on the finisher controller
PCB.
0004 02 Response timed out - Replace finisher controller PCB.
Remove the EEPROM from the old board and mount
it on the new board. If the problem is not solved,
replace with a new EEPROM.
0007 02 Finisher controller PCB malfunction - Replace finisher controller PCB.
Remove the EEPROM from the old board and mount
it on the new board. If the problem is not solved,
replace with a new EEPROM.D45