Canon Finisher-AB1, Service Manual

Page: 389 / 463

Chapter 5
5-41
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
F-5-125
6) The setting preparations are completed by
pressing SW385.ÅB
7) Since “2” appears on the LED when SW384 is
pressed twice, press SW385 once again.
This now completes the bufferless mode 2 settings.
5.3.2.19 Assist stopper position
adjustment
0016-4797
This adjustment is performed when there are
variations in the position of the topmost sheet of the
delivered stack.
The operation procedure is described below.
1) Open the front door.
2) Pull out the saddle unit [2] by holding the lever
[1]; and then, open the saddle right guide [3].
F-5-126
3) Place the A4 or letter size sheets [1] in the
intermediate processing tray in the direction of the
arrow. Then, measure the degree of displacement [A]
between the paper edge stopper [2] and the assist
stopper [3].
If the measured value (+A or -A) is outside of the
reference value (0+0.5 mm), perform the adjustment
to make the degree of displacement falls within the
range of the reference value.
F-5-127
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
[2]
[1]
+A
-A
[1]
[1] [2] [2] [3]
[1] [2] [2] [3]