Canon Finisher-AB1, Service Manual

Page: 391 / 463

Chapter 5
5-43
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-132
4) Remove the screw [2], and detach the switch
cover [1].
F-5-133
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
F-5-134
6) The preparations for the staple inlet guide height
adjustment are completed by pressing the push
switch (SW385) [1].
F-5-135
7) The adjustment amount is determined by pressing
either one of the push switches: SW383 [1] or
SW384 [2].
When SW383 is pressed once, "-1" appears on the
LED [3], and the staple inelt guide height position
[4] is lowered.
On the other hand, when SW384 is pressed once,
"+1" appears on the LED [3], and the staple inlet
guide height position [5] is raised.
Adjustment range: +4 to -4 (Each 1 setting value
change results in the movement of 0.5mm.)
<Reference>
When the foregoing fault has occurred, it can be
remedied by changing the adjustment value in the
negative direction.
F-5-136
[1]
[2]
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[2]
[3]
[1]