Canon Finisher-AB1, Service Manual

Page: 384 / 463

Chapter 5
5-36
5.3.2.14 Adjusting the Saddle Lead Edge
Stopper Position
0015-2242
Go through the following steps if the saddle folding
position has become displaced.
1) Generate a print using the saddle assembly, and
measure the displacement (C) of the folding
position.
F-5-108
2) Slide out the saddle assembly; then, remove the 6
screws [1], and detach the PCB cover [2].
F-5-109
3) Loosen the fixing screw [1] of the lead edge
stopper, and change the position of the stopper to
suit the displacement (C) of the following
position measured in the foregoing step. (A single
index will cause a change of 1 mm.)
Specifically, insert a Phillips screwdriver into the
adjusting hole, and move the screwdriver up/
down to move to a different index.
F-5-110
5.3.2.15 Adjusting the Saddle Alignment
Reference
0015-2243
Make the following adjustments if the saddle
reference is displaced.
1) Turn on the finisher.
2) Turn on the copier's power switch, and see that it
is in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-111
[C]
[2]
[1]
[1]
[1]
[3] [2]
[1]