Canon Finisher-AB1, Service Manual

Page: 134 / 463

Chapter 5
5-28
F-5-86
4) Detach the switch cover [1] by removing the
screw [2].
F-5-87
5) Set the DIP SW382 [1] on the Switch PCB as
shown in the figure below. EEPROM is
initialized by pressing the switches in the order of
SW385,SW384,SW383, once for each.
F-5-88
6) Make the following adjustments:
- Sensor light intensity adjustment
- Swing guide speed adjustment
- Alignment plate width adjustment
- Staple position adjustment (1-point binding at
the rear)
- Staple position adjustment (1-point binding at
the front)
- Staple position adjustment (2-point binding)
- Stapled stack delivery adjustment (lower
delivery)
- Stapled stack delivery adjustment (saddle
delivery)
- Feed belt position adjustment
- Saddle leading edge stopper position adjustment
- Saddle binding position adjustment
- Saddle folding position adjustment
- Punch hole position adjustment (side
registration direction)
- Punch hole position adjustment (feed direction)
- Bufferless mode 1
- Bufferless mode 2
- Staple inlet guide height adjustment
- Paddle height adjustment
- Adjustment at poor tray stackability (when the
upper curl occurs)
- Adjustment at poor tray stackability (when the
lower curl occurs)
- Adjustment at poor tray stackability (run over
when using thin paper)
- Tray stacking limit cancellation adjustment
[1]
[2]
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381