Canon Finisher-AB1, Service Manual

Page: 304 / 463

Chapter 4
4-10
4) Shift the handling tray aligning plate (front) [1] in
the direction of the arrow, and remove the screw
[2] and the claw [3]; then, detach the handling
tray aligning plate (front).
F-4-36
5) Remove the handling tray (front) [1].
- 2 screws [2]
F-4-37
6) Loosen the screw [1], and free the belt [2] from the
gear [3].
F-4-38
7) Remove the aligning motor (front) [1].
(page 5-12) Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-15) Reference[Adjusting the Aligning
Plate Width]
- 2 clamps [2]
- 1 connector [3]
- 2 screws [4]
F-4-39
4.3.4 Rear Alignment Motor
4.3.4.1 Before Removing the Alignment
Motor (rear)
0015-2302
1) Remove the stacking wall (upper). (page 4-
5) Reference[Removing the Stacking Wall
(upper)]
2) Remove the stacking wall (lower). (page 4-
5) Reference[Removing the Stacking Wall
(lower)]
3) Remove the handling tray unit. (page 4-
23) Reference[Removing the Handling Tray
Unit]
[3] [1] [2]
[1] [2]
[2] [1] [3]
[1]
[2]
[3]
[4]