Canon Finisher-AB1, Service Manual

Page: 397 / 463

Chapter 5
5-49
8) This adjustment is completed when the push
switch SW385 [1] is pressed again.
F-5-160
5.3.2.24 Adjustment at poor tray
stackability (run over when using thin
paper)
0016-6230
This adjustment is performed either when poor tray
stackability occurs with thin papers shown in the
figure below or when the EEPROM (IC107) on the
finisher controller PCB is replaced.
F-5-161
<Memo>
By executing this adjustment, the finisher reduces
the feeding speed. As a result, the degree of curl of
thin paper is reduced; thus, the poor tray stackability
mentioned above is reduced.
Details of the adjustment procedure are provided
below.
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-162
4) Remove the screw [2], and detach the switch
cover [1].
F-5-163
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
F-5-164
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
[1]
[2]
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]