21
Ceiling Mount
Do not use the screw holes for tripod but use the mounting bracket to install the camera.
When installing the product outdoors using a pole, etc., to prevent rain and bird damage, prepare mounting brackets
of
290 ± 5 mm (mounting brackets of larger than
300 mm will be captured) matching the dimensions of the four
M6 taps on the bottom surface.
The logo plate can be turned upside-down. Pull up gently the right and left sides of the logo plate to pull it out, rotate
it and push it back into place.
Using a Tripod
Attach the tripod by fixing a screw to the screw hole for tripod.
Use 1/4-20UNC screws and tighten them securely, and set the tripod on a flat surface with no steps.
Attaching the Connector Cover
Preparation before Attaching
• Thread each cable through the connector cover (1).
• Connect each cable to each connector on the receptacle unit. Make sure that the cables are securely attached so
that they will not come off. Use a cable clamp for the power cable (P. 15). For HDMI cable, if necessary, use a
cable retaining part to take measures to prevent it from disconnecting.
• If not using an IP connection, configure the control protocol.
• Take necessary measures against lightning damage.
5 6 mm
1/4-20UNC
(1)
(3)
(4)
(2)
