Can-Am Commander Electric LSV, Operator'S Manual

Page: 66 / 114

BATTERIES
tmo2012-005-051_b
10 LED DISPLAY
1. Ammeter 6 bars
2. Ammeter 5 bars
3. Ammeter 4 bars
4. Ammeter 3 bars
5. Ammeter 2 bars
6. Ammeter 1 bars
7. 80% charge complete
8. 100% charge complete
9. AC ON indicator
10. FAULT indicator
Ammeter (Amber)
Solid: Displays approximate scale of
current output during charging.
Approximate current indicated by each
Ammeter LED:
INDICATOR BARS CURRENT (A)
6 bars 18
5 bars
15
4 bars 12
3 bars 9
2 bars 6
1 bars 3
Note:
– A flashing “I” indicates the current
output is well below the “I” level.
– These are approximate levels.
A flashing indicator bar denotes a high
internal temperature. The current out-
put is reduced to the flashing indicator
level.
80% Charge (Amber Display)
Solid: Bulk charge phase complete,
80% charge reached. Charger begins
absorption phase.
100% Charge (Green Display)
Solid : Charging complete. Charger
begins maintenance mode.
Flashing : Absorption phase com-
plete. Charger completes finish phase
AC ON (Amber Display)
Solid : Vehicle is connected properly
and batteries are charging.
Flashing : Low AC Voltage, check
voltage and verify extension cord for
any damage and make sure it meets
the requirements. Refer to
BATTERY
CHARGING .
Fault (Red)
Flashing: Charger error. Contact an au-
thorized Can-Am dealer.
Battery Charging
BATTERY CHARGING REQUIREMENT
110 V AC grounded outlet
Vehicle extension cord
10 GA extension cord, max length 30 m
(100 ft) provided by customer as needed
_______________
63