Can-Am Commander Electric LSV, Operator'S Manual

Page: 54 / 114

MULTIFUNCTION GAUGE (ANALOG/DIGITAL)
MESSAGE DESCRIPTION
BRAKE
Message displayed when the brakes are applied continuously for
15 seconds and vehicle speed is over 5 km/h (3 MPH).
SEAT BELT
When the seat belt is not buckled and the vehicle speed is less than
10 km/h (6 MPH), the message is displayed and the pilot lamp will
be lit.
ENGINE
LIMITATION
ENGAGED FASTEN
SEAT BELT When the seat belt is not buckled and the vehicle speed is above
10 km/h (6 MPH), the message is displayed and the pilot lamp will
flash. The motor torque is limited and the vehicle maximum speed
is approximately 15 km/h (9 MPH).
ECO MODE ACTIVE
Displayed when the ECO button is pressed.
DIFFERENTIAL
LOCK
Displayed when differential lock button is pressed
8) Multifunction Display
The vehicle speed, the motor current
and the motor RPM can be displayed.
Refer to MODE (M) BUTTON in this
section.
9) Battery State of Charge
Bar graph that continuously indicates
the level of energy left in the batteries.
10) Secondary Digital Display
Displays useful real time information to
the rider. For display function informa-
tions, refer to
SET (S) BUTTON
.
11) Drive Mode Position Indicator
Displays the selected mode position.
12) Motor Temperature Indicator
Bar graph that continuously indicates
the motor housing temperature.
13) Numerical Display
The vehicle speed or the motor power
output can be displayed. Refer
MODE
(M) BUTTON
.
14) 2WD/4WD Indicator
When this indicator is ON, the 4WD
system is activated.
Gauge Setup
Setting Metric/Imperial Units
Go see a Can-Am dealer for adjust-
ments.
Setting Clock
1. Press MODE (M) button to select
clock display.
2. Push and hold MODE (M) button for
three seconds.
3. Press MODE (M) button to select
12:00 AM PM or 24:00 time base.
4. If 12:00 AM PM time base is se-
lected, A or P flashes. Press MODE
(M) button to select A (AM) or P
(PM).
5. Press SET (S) button to change
hours.
6. Press MODE (M) button to switch to
minutes (minutes flash).
7. Press SET (S) button to change min-
utes.
8. Press MODE (M) button.
Setting Language
The gauge display language can be
changed.
Refer to an authorized
Can-Am dealer for language availability
and setup the gauge to your prefer-
ence.
_______________
51