Calrec SUMMA, User Manual

Page: 137 / 198

Surface Delay Controls
Push the DELAY control mode button to populate each pair of control cells on the surface with delay controls for each
path. Use the bottom control cell to control path delay, the button turns path delay ON/OFF and the rotary sets the delay
time. The top control cell only becomes active when input or output delay are assigned to the associated path.
FIGURE 2 -
DELAY CONTROL CELLS
Global Delay Controls
Tap ‘show settings’ in the Show menu and then select ‘delay units’. Three global delay settings are available:
• Delay can be viewed in either time or frames across the surface, select TIME or FRAMES and all new delay
modules will be displayed according to your choice. If you wish to extend this selection to all existing delay
assignments tap
APPLY TO EXISTING DELAYS .
• If delays are displayed and controlled in frames rather than time, a frame-rate must be set. Changing the frame-rate
from this screen changes is for all delays assigned on the surface which are in frames.
• When setting delays wither a rotary control or an up/down stepper can be used. If the stepper is used, the step size
can be set at either 1 frame or 0.5 frames.
FIGURE 3 -
SHOW SETTINGS—DELAY CONTROLS
CALREC
Putting Sound in the Picture
137