CAB Tharo Apollo 4, Operator'S Manual

Page: 53 / 118

53 cab - Produkttechnik GmbH / Tharo Systems, Inc.
F
Cut Position
The parameter "Cut Position" is only important for the Apollo 4 with integrated
cutter ( Apollo 4/200C , Apollo 4/300C ). The distance between cutting edge and
rear label edge may be altered at these devices by using this parameter.
Normally, with the initial offset value of "0" the cutting edge is in the middle of
the gap between two labels. Adjustments have to be carried out only once
after a cutter has been installed. (range from -.33 to +.33 in or -8.4mm to
+8.4mm) If the cut position value is positive, the media will be advanced
before it is cut, that means there is a greater distance between the cutting edge
and the rear edge of the label.
It is recommended that you carry out changes for single print jobs in the
software. (e.g. if the cut is not wanted in the middle of the gap)
The software provides a second value for individual adjustments.
Any front panel value and software command value are totaled together for
printing.
The current field to be changed is flashing in the display.
4 Interface
6 Peel Position
5 Cut position
Cut position
+ x.x mm
Cut position
- x.x mm
Cut position
± 9.x mm
Cut position
± 0.x mm
Cut position
± x.9 mm
Cut position
± x.0 mm
*
*
*
*
*
*
Cut postion
± x.x mm Yes
Cut position
± x.x mm No
Confirmation
Sign (+ or -)
1/10 mm
mm
Fig. 9 f Set "Cut Position" parameter