CAB Tharo Apollo 4, Operator'S Manual

Page: 41 / 118

41 cab - Produkttechnik GmbH / Tharo Systems, Inc.
ONL key Stores the chosen settings of the setup parameters and
completes the SETUP mode.
(i.e. switch into ONLINE mode/ LED ONL on)
FF key Skips to next setup parameter.
Reduces numerical setup values.
CAN key Skips to previous setup parameter.
Increases numerical setup values.
PSE key Confirms selected settings for parameters.
System Mode SETUP
To enter the SETUP mode, use either one of the procedures described below :
either : press both keys, the key and the key
simultaneously when switching on the printer, and keep them
pressed down, until the system test is completed;
or : in ONLINE mode, press both keys, the key and the
key simultaneously for at least 5 seconds.
In SETUP mode, various printer parameters can be specified to suit the current
print requirements. (for details see Chapter 9)
Display
Following the completion of the system test, the display briefly shows "SET-
UP", followed by "Land" or "Country". Depending on the selection, all of the
setup parameters and their settings will be shown.
LED Display
All LEDs off.
Function Keys
Table 8 g Function keys in SETUP mode