CAB Tharo Apollo 4, Operator'S Manual

Page: 101 / 118

C-1 cab - Produkttechnik GmbH / Tharo Systems, Inc.
CAN key short pressing : Cancels the current print job.
Switch to the next job, which is available
in the input buffer
longer pressing (>1s): Cancels the current print job.
Clears the input buffer
(LED CAN blinks),
Switch into ONLINE mode.(LED ONL on)
PSE key Continues current print job after error correction.
Switch into PRINT mode.
(LED ONL on, LED CAN off, LED PSE off)
Appendix C - Error Messages/ Problem Solution
The following section describes possible errors and their suggested solutions.
The Apollo 4 is equipped with a comprehensive self diagnostic system which
will indicate errors in the display of the printer. Also, the operator will be
informed by the LEDs whether the fault is correctable and will, therefore, allow
to continue the current print job after corrections (e.g. "Out of paper"), or the
fault may require you to cancel the current print job.
Correctable Errors
While processing a print job, an error has occured which may be corrected by
the operator, and also allows you to continue the print job after fault correction.
Display
The top line of the display shows alternately the type of fault and the total of the
remaining labels of the current print job.
LED Display
LED CAN on, LED PSE is flashing.
If an applicator is connected : LED FF is flashing.
Function Keys
Table C-1 Function keys in mode FAULT-CORRECTABLE