67
cab Produkttechnik GmbH & Co KG
A3-2 / A3 / A4 / A6
8. Printer Configuration
or tear off the last label at the tear-off plate. When a new print job is started,
the label material will be fed back until the front edge of the first label is
repositioned under the printhead.
If the parameter is OFF, the label feed forward stops immediately after the last
label has completely passed the printhead.
Backfeed
In cut and peel-off mode, the material will be stopped in a position where the
leading edge of the following label has already been forwarded beyond the
printhead. The printer will then backfeed the label material from its cut/
dispense position to the printhead. Therefore, the next label can be printed
completely.
A backfeed will always be performed if the parameter is set to "always". If the
setting is set to "smart", the backfeed will only be performed if the front label is
in its cut/dispense position and the printer has not yet received all of the data
for printing the following label. Otherwise, the print of the second label will be
started, but only completed once the first label has been removed.
Pause reprint
When this option is enabled (On), it is possible to print additional labels by
pressing the
key after the print job has completed, as long as the
internal memory of the printer has not been cleared by pressing the
key.
Error-Reprint
When a recoverable error occurs while printing, this option will determine how
the last label will be handled. If this option is enabled (On), the last label will be
reprinted once the error has been cleared. If this option is disabled (Off), the
print job will continue with the next label.
Barcode error
When this option is enabled (On), after the recognition of invalid bar code
contents or invalid bar code sizes the print job will be stopped.
If this option is disabled (Off), the printer tries to replace invalid data by valid
characters (e.g. "0"). If the bar code size is invalid, instead of the bar code a
grey box will be printed.
Width ASCII dump
The ASCII Dump mode (see chapter 9) provides a method to print the control
sequences sent to the interface. In this mode the data received will be printed
in text format depending on the selected character set.
Summary of Contents for a3-2
Page 1: ...Edition 10 04 Thermal direct Printer Transfer Printer Operator s Manual...
Page 77: ...77 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 A B D C E F 9 Test Options Fig 9l Status Print...
Page 83: ...83 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9o Printhead Profile...
Page 87: ...87 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9s Test Grid...
