E-2
cab Produkttechnik GmbH & Co KG
A3-2 / A3 / A4 / A6
5
6
1
7
Fig. E-2 Changing Printhead A3-2/A3/A4 (I)
1. Remove the media from the printer.
2. Swing the lever (
6
) to the position shown in figure E-2. In this position, the
printhead assembly is unlocked but still lying on the print roller.
3. Loosen the printhead locking screw (
5
) using the Allen key (
7
).
4. To lift the printhead assembly, swing the lever (
6
) clockwise until it stops.
5. Remove the printhead (
1
) from the pins (
11
) on the printhead carriage.
WARNING !
Unplug the power cord from the power source before starting!
CAUTION !
Protect the printhead against damage by electrostatic dischargement !
- Put the printer on to a grounded conductive surface !
- Ground yourself during printhead replacement for example using a
grounded wrist-strap !
- Do not touch the connector pins of the printhead by naked hands !
Make sure the glass surface on the printhead is not touched by sharp
objects or your hand!
Appendix E - Replacing Assembly Units
Summary of Contents for a3-2
Page 1: ...Edition 10 04 Thermal direct Printer Transfer Printer Operator s Manual...
Page 77: ...77 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 A B D C E F 9 Test Options Fig 9l Status Print...
Page 83: ...83 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9o Printhead Profile...
Page 87: ...87 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9s Test Grid...
