61
cab Produkttechnik GmbH & Co KG
A3-2 / A3 / A4 / A6
8. Printer Configuration
Parameter
Meaning
Cutter
(Only displayed if the cutter is attached)
Applicator
(Only displayed if the optional Tamp Applicator
is attached)
Brightness LCD
Sets the brightness of the display
Default :
8
Contrast LCD
Sets the contrast of the display
Default :
8
Time Powersave Amount of time before switching to
powersave mode
Default :
10 min
Debug mode
Activates the debug mode
Default :
Off
Selection
1..12
6..11
60 min
...
0 min
On
Off
Table 8c Overview of the "Machine parameters" Menu (continuation)
Printhead position X
Using this setting will shift the entire print image to the left on the label. This
parameter should only be altered if you are printing the same format on several
printers, and the printed image is not consistent on each printer.
NOTICE !
The value of Printhead position X cannot be greater than the difference of
the printhead width and the defined label width in software. A value
greater than the difference will be ignored and the actual difference will
be used in place. For example, if the printhead width is 104mm and the
label width defined in software is 100mm, the printer will only accept a
value of 4mm or less for printhead position X. If Printhead position X is
set for 6mm, the printer will only shift the label 4mm.
The Printhead position X value to be changed will be flashing on the display.
It is possible to adjust the value for individual jobs using software. The front
panel values and software command values will be totaled together for printing.
Summary of Contents for a3-2
Page 1: ...Edition 10 04 Thermal direct Printer Transfer Printer Operator s Manual...
Page 77: ...77 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 A B D C E F 9 Test Options Fig 9l Status Print...
Page 83: ...83 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9o Printhead Profile...
Page 87: ...87 cab Produkttechnik GmbH Co KG A3 2 A3 A4 A6 9 Test Options Fig 9s Test Grid...
