Burstner I 2012, Instruction Manual

Page: 30 / 292

30
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Before the journey
3
3.6 Entrance step (partially special equipment)
The vehicles have an electrically extendable entrance step.
Before stepping on the entrance step, fully extend it (Fig. 8).
Extending:
„
Press the rocker button (Fig. 9,1) down and hold it pressed (at least
3 seconds) until the entrance step has extended completely.
Retracting:
„
Press the rocker button (Fig. 9,1) up until the entrance step has retracted
completely.
X
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
X
Do not stand in the direct range of the entrance step while it is being
retracted or extended.
X
Do not step on the entrance step until it has extended completely. There
is a risk of injury.
X
Do not under any circumstances raise or lower persons or loads with the
entrance step.
Z
Take note of the different step heights and make certain that the ground is
firm and even when exiting.
Z
Do not grease or lubricate the pivot bearing and joints of the entrance step
(see chapter 11).
Z
The button to operate the entrance step is located on the inside of the
vehicle in the area of the conversion door.
Z
If the entrance step is not retracted and locked in place correctly, a red indi-
cator lamp lights up on the dashboard when the ignition is switched on.
Z
Follow the warning notice on the entrance step.
Fig. 8 Warning notice for entrance
step
Fig. 9 Operating button for entrance
step