Burstner I 2012, Instruction Manual

Page: 175 / 292

175
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Appliances
9
Change-over between
energy sources
When changing over from 230 V or 12 V to gas, delay times are built into the
AES. For example, when changing over from 12 V operation to gas operation,
a 15 minute delay is built in the AES. This prevents a change-over to gas oper-
ation when the vehicle is stopped briefly and the engine is switched off (e.g.
stop to fill tank).
Refrigerating temperature
control
When turned on the first time the refrigerator automatically selects the middle
thermostat position. This position can be adjusted manually by using the con-
trol knob (Fig. 189,6). The indicator lamps (Fig. 189,5) show the selected ther-
mostat position. The refrigerating temperature for the three types of energy is
set with the control knob. It takes a few hours till the refrigerator reaches its
normal operating temperature. When changing over the operating mode the
thermostat setting will be maintained. The refrigerating temperature is retained
regardless of the type of power being used.
Frame heater (FH)
High external temperatures and high humidity can cause drops of water to
form on the metal frame of the freezer compartment. This is why the refriger-
ator is equipped with a frame heater for the freezer compartment. If the tem-
perature and humidity are high, switch on the frame heater by pressing the
button (Fig. 189,1). This prevents corrosion. If the frame heater is switched on,
the indicator lamp (Fig. 189,2) will be lit.
Manual operation
Switching on:
„
Open the regulator tap on the gas bottle and the gas isolator tap "Refriger-
ator".
„
Select the energy type with the energy selector switch (Fig. 189,3). The
respective indicator lamp (Fig. 189,4) lights up green.
„
Adjust refrigerating temperature with the control knob (Fig. 189,6). The
indicator lamps (Fig. 189,5) show the selected thermostat position.
When the gas operation is faulty, the "GAS" indicator lamp (Fig. 189,4) flashes
red.
When operated with 12 V, the refrigerator draws power only from the living
area battery.
X
Open flames are prohibited at petrol stations. If the stop takes longer
than 15 minutes, the refrigerator has to be turned off at the energy
selector switch.
Z
If the frame heater is switched on, it will always consume current. There-
fore, switch off the frame heater if the vehicle engine is off and the vehicle
is not connected to the 230 V power supply.
Z
If the refrigerator is manually set to "12 V", it will constantly consume cur-
rent. Therefore, switch over to gas operation when the vehicle engine is
not running, and the vehicle is not connected to the 230 V power supply.