Burstner I 2012, Instruction Manual

Page: 150 / 292

150
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Appliances
9
9.2 Heater
Start-up When lighting the heater for the first time a small amount of smoke and odour
will occur. Immediately set the operating switch of the heater to its highest
position. Open doors and windows and ventilate well. Smoke and odour will
disappear by themselves after a while.
9.2.1 Models with waste gas vent on the right-hand side of the
vehicle
9.2.2 To heat properly
Hot air distribution Several air outlet nozzles (Fig. 157) are built into the vehicle. Pipes conduct
the warm air to the air outlet nozzles. Turn the air outlet nozzles in a suitable
position so the air can escape as required. To avoid draft close the air outlet
nozzles on the dashboard and set the air distribution of the base vehicle to air
circulation.
Adjusting the air outlet
nozzles
z
Fully open: Full hot air stream
z
Half or partially open: Reduced hot air stream
X
Never let gas escape unburned due to danger of explosion.
X
Never run the heater in gas operation when refuelling, on ferries or in the
garage. Danger of explosion!
X
Never operate the heater in gas operation in closed spaces (e.g.
garages). Danger of poisoning and suffocation!
X
The waste gas vent may neither be closed nor blocked.
X
Do not use the space behind the heater as a storage compartment.
Z
The circulation fan of the hot-air heater automatically goes on when the
hot-air heater is activated and is automatically switched off and on during
operation by means of a thermostat control. This puts an immense strain
on the living area battery, if the vehicle is connected to an external 230 V
power supply. Take into consideration that the living area battery only has
limited reserves of energy.
X
If the awning is put up and the heater is running in gas operation,
exhaust gases from the heater can escape into the awning area. Danger
of suffocation! Make sure the area is sufficiently ventilated.
Fig. 157 Air outlet nozzle