Burstner I 2012, Instruction Manual

Page: 27 / 292

27
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Before the journey
3
The load rack permits transport of a load (e.g. a motorcycle or a motor scooter)
weighing up to 150 kg. Always remove the load rack after use.
Installation:
„
Apply the handbrake.
„
Insert the supports on the left and on the right into the holders on the frame
and secure them with a quick closure (Fig. 4,1).
„
Connect the electrics between the load rack and the vehicle.
Removal:
„
Apply the handbrake.
„
Disconnect the electrics between the load rack and the vehicle.
„
Open the quick closure (Fig. 4,1) and pull the support from the holders on
the frame.
3.3.10 Load rack SAWIKO (special equipment)
X
Always make sure to store the load roadworthy and secure it against
falling.
X
The load may not jut out beyond the maximum width of the vehicle. The
lighting and the official licence plate on the load rack may not be covered
by the load.
Z
The load rack and caravan coupling may not be used simultaneously.
Z
The load rack has a EG type approval number.
Z
Have your dealer or service centre install the load rack.
Z
Observe the country-specific regulations.
Z
Also read the manufacturer's instruction manual.
Fig. 4 Quick closure
X
Do not exceed the rear axle load.
X
Heavy loads behind the rear axle can reduce the load on the front axle
due to the leverage effect (
). This applies especially to long rear
extensions, if a motorbike is transported on the rear carrier or if there is
a heavy load in the rear storage space. The release of the front axle neg-
atively affects the driving quality, especially for front-driven vehicles.