Burstner I 2012, Instruction Manual

Page: 217 / 292

217
I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Maintenance
12
„
After use, firmly close the cap of the tank cartridge.
„
Insert a new, sealed original tank cartridge into the tank cartridge holder.
„
Secure the tank cartridge with the securing belt.
„
Open cap and keep safe.
„
Screw tank cartridge connection onto the new tank cartridge.
„
In the "Main Menu > Fuel Cartridge" menu, specify the tank cartridge size
used and confirm with "OK".
12.5.2 Refilling service fluid
„
Turn off fuel cell and remove the device's connector plug.
„
Remove the air discharge hose.
„
Cut off the tip of the nozzle on the refill bottle.
„
Pour the entire content of the refill bottle into the connection for the air dis-
charge hose.
„
Re-insert the air discharge hose.
„
Plug the device's connector plug back on again.
„
Press the reset button.
12.6 Alde hot-water heater
Z
Only use original SFC refill sets.
Z
Only replenish service fluid if a message to do so appears on the operating
panel.
Z
Ensure that no dirt or foreign bodies enter the filling hole.
Z
Original refill sets are available from all authorised dealers and service cen-
tres.
Z
Wipe up any spilled service fluid with a cloth.
Z
Check the level of the heating fluid regularly on the compensator reservoir.
Z
During or after the first operating hours of the hot-water heater, the filling
level may fall below the minimum mark. If this is the case, top up the
heating fluid.
Z
We recommend to bleed the heating system after the initial heater opera-
tion and to check the glycol content.
Z
Have heating fluid changed by an authorised dealer or a service centre at
intervals of approximately two years as corrosion-protection wears off after
some time.
Z
Top up heating system with a water-glycol mixture (60 : 40) only. This mix-
ture offers frost protection up to approx. -25 °C. When topping up hot-water
heaters that are connected to the engine's cooling circuit, please observe
the instructions in the instruction manuals of the manufacturers.
Z
Further information can be obtained in the device manufacturer's instruc-
tion manual.