Burstner Goldie, Manual

Page: 172 / 232

172
I-Modell - 07/07 - Ausgabe 03/07 - 1512317 - BUE-0056-00EN
Maintenance
12
Switch off the hot-water heater and allow it to cool down.
Open bleeding valve (Fig. 185,1) and leave open until no more air escapes.
Close bleeding valve.
Repeat this procedure at all bleeding valves.
Check to see if the hot-water heater warms up.
12.5.4 Position of the bleeding valves
12.6 Independent vehicle heater
Use the independent vehicle heater for 10 minutes at least once a month with
a cold engine and smallest fan settings.
Before the heating season starts, have the independent vehicle heater
checked by an authorised specialist workshop.
12.7 Air conditioning unit (Truma)
A lint filter (Fig. 186,1) for the air circulation suction system is at the front of the
air conditioning unit. The lint filter must be cleaned at regular intervals, at least
twice a year however, and replaced if necessary.
Position of the bleeding valves
I 821 The drain for complete emptying is under the floor below the water tank (access via
the service flap)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the rear area of the central seating group, access via the service flap
Above the divan behind the curtain
In the furniture cabinet at the left access
In the passage in front of the toilet compartment
On the rear bed, left and right
Never operate the air conditioning unit without a lint filter. Without a lint
filter, the vaporiser becomes dirty and the capacity of the air conditioning
unit is consequently impaired.
Condensation can enter the vehicle if the condensation drain is clogged up.
Keep the condensation drain free from dirt, leaves and similar.
Fig. 186 Air conditioning unit (Truma)