Burstner Goldie, Manual

Page: 128 / 232

128
I-Modell - 07/07 - Ausgabe 03/07 - 1512317 - BUE-0056-00EN
Appliances
9
Gas and 230 V electrical
operation
Switching on: Open the regulator tap on the gas bottle and the gas isolator tap "Heater/
boiler".
Set the sliding switch (Fig. 131,7) to the required output level.
Set sliding switch (Fig. 131,5) to gas operation.
Set sliding switch (Fig. 131,3) to either "Heater and hot water" (Fig. 131,4)
or to "Hot water" (Fig. 131,2).
The red indicator lamp (Fig. 131,6) goes on whenever a fault occurs.
Switching off: Set the sliding switches (Fig. 131,3, 5 and 7) to "0".
Close the gas isolator tap "Heater/boiler" and the regulator tap on the gas
bottle.
Filling/emptying the boiler The boiler can be supplied with water from the water tank.
Filling the boiler with water: Close the drain cock(s). Position the rocking lever (Fig. 132,1) horizontally.
Switch on 12 V power supply on the panel.
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
Close all water taps.
Emptying the boiler: Switch off boiler.
Open all water taps and set to the central position.
Open drain cock(s) (Fig. 132). To do so, set the rocking lever (Fig. 132,1)
in a vertical position. The boiler is drained to the outside.
Check whether the water has been drained completely from the boiler
(approx. 12.5 litres).
If gas and 230 V electrical operation is selected and if the vehicle is con-
nected to the 230 V power supply, then the boiler at first only operates in
230 V electric operation. Only if the heat output is insufficient does the gas
operation also automatically switch on.
Depending on the model, the vehicle is fitted with one or two drain cocks.
Fig. 132 Drain cock