Burstner Goldie, Manual

Page: 118 / 232

118
I-Modell - 07/07 - Ausgabe 03/07 - 1512317 - BUE-0056-00EN
Appliances
9
9.2.5 Auxiliary heat exchanger (partially special equipment)
The auxiliary heat exchanger is built into the bench seat.
The auxiliary heat exchanger may be used to provide the vehicle's living area
with additional heat during the journey.
The auxiliary heat exchanger is integrated into the heat circulation of the base
vehicle and is therefore only in operation when the vehicle engine is running.
Switching on: Push the sliding regulator (Fig. 121,1) of the flow control downward to the
desired position. The water circulation is open.
Turn the fan switch (Fig. 121,2) for the circulation fan in a clockwise direc-
tion.
Switching off: Turn the fan switch (Fig. 121,2) to " ".
Push the sliding regulator (Fig. 121,1) of the flow control upward as far as
it goes.
9.2.6 Electrical floor warming unit (special equipment)
The fan on the auxiliary heat exchanger can be used for ventilation.
The heat output is continuously adjusted.
Fig. 121 Operating controls for auxiliary
heat exchanger
On models with electrical floor warming unit, never drill holes in the floor
or screw in any screws. Careful with sharp objects. There is danger of a
power cut or a short circuit due to damage to a heater wire.
Do not cover the transformer. Danger of overheating!
The electrical floor warming unit only operates if the vehicle is connected
to the 230 V power supply.
The output of the electrical floor warming unit alone is not sufficient to heat
the living area.