42
the top, left, bottom and right side lines
construction lines to make the diagonals
PANEL PRO
A standard ATI3 cutout dimensions
are 3.21 wide, 3.21 high, 3.92
diagonal across the corners. The
distance between mount holes is
3.06.
We will first draw the cutout.
Select (or create layer 2)
Divide the height and width (3.21)
by 2 = 1.605
Divide the diagonal 3.92 by 2 =
1.96
It is good to start and finish on the
top center of a ati or square type
instrument.
Create a line from 0,1.605 to –
1.605,1.605 to create the left half of
the top line. Note that it extends
left, which when connected into a polyline with the pedit command will rotate counter
clockwise.
Create a line from –1.605,1.605 to –1.605,-1.605, the left side of the cut out.
Create a line from –1.605,-1.605 to 1.605,-1.605, the bottom line.
Create a line from 1.605,-1.605 to 1.605,1.605, the right side line.
Create a line from 1.605,1.605 to 0,1.605, the right half of the top line
Draw a line from the lower right
corner using object snaps (end point)
diagonally to the left top corner, also
using the end point snap to precisely
locate the end point.
