6
TRANSPONDER / PASSLOCK III
purchase one through JBS Technologies, but make sure
they program all keys to the vehicle since learning just
one transponder could erase all other key transponders
(including the key used for the Bypass Module).
Again, an extra
Programmed Transponder
Ignition Key
that starts the vehicle, will need to
be placed inside the Anti-Theft Bypass Module.
Pull apart the case and place the Programmed
TRANSPONDER KEY
, inside the
10-Wire Loop
on
the circuit board. Transponder Keys are directional
and must be placed along the same direction that
the key would lay in the Ignition Switch. Use the
double stick foam tape provided, one layer on the
circuit board and then the Transponder Key, and
finally the second double-stick foam tape layer on
top of it to hold key securely in place, See Below:
The
TRANSPONDER LOOP Antenna
must be
1.
2.
3.
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogse-
curity.com or call our toll-free Tech Support Hotline at:
800-878-8007.
BEFORE YOU BEGIN
If your vehicle has an anti-theft system, you will need an addi-
tional module, Part #791.
Congratulations, you have purchased one of the most advanced remote
starter systems ever made. Your new remote starter is a technological
breakthrough utilizing the most advanced, state of the art technology
and components. The dependability and variety of features make Bulldog
Security the leader in the industry. Enjoy your new remote starter for
years to come!
This remote system is designed to start your vehicle by sending a com-
mand signal from the remote transmitter. It is important that your instal-
lation be done in a well-ventilated area.
It is the responsibility of the
owner to ensure that the remote system is not used to start the
vehicle in an undesired location.
It is recommended that a carbon monoxide detector be installed in
the living area near a location where the vehicle may be garaged.
Since there are many different makes and models of vehicles,
visit our website, www.bulldogsecurity.com.
Read this manual thoroughly before starting the installation.
TACH/TACHLESS OPERATION
In most cases the decision to go with tachless mode will save time during
the installation. If your vehicle is hard-starting then you should use tach
mode.
MAKE SURE YOU PLACE THE WARNING STICKER UNDER YOUR HOOD.
59
Summary of Contents for DELUXE 200B
Page 1: ......
