Bulldog Security DELUXE 200B, Installation Manual

Page: 4 / 32

61 4
TRANSPONDER / PASSLOCK III
Note : If the vehicle does not start with the Remote
Starter or runs for approx 5 seconds and shuts
down, try adjusting or changing the position of the
Transponder Key in the Bypass Module or adjusting
the position of the (2)Two Loop Antenna wire around
the Transponder Pick-up/Receiver Antenna as men-
tioned above.
When connecting the Anti-Theft Bypass Module to
your Remote Starter, you will need to activate this
Bypass Module by connecting it in different ways
depending on the Remote Starter you have. Attach
the WHITE/GREEN (-)Security Bypass Output
wire from the 8-Pin Harness to: if the unit you are
using has a 4-Relay Pack , tap this WHITE/GREEN
wire into the Thin WHITE wire in the middle of the
3-Pin Plug , if the Remote Start does not have a
4-Relay Pack and the Relays are On-Board, connect
the WHITE/GREEN wire to the WHITE, YELLOW
or YELLOW BLACK (-)Negative Ignition Output
or (-) Security Bypass Output wire from the Main
Harness on these Remote Starters. On the DELUXE
200 or DELUXE 500 Models , connect this GREEN/
WHITE wire to the BLUE/BLACK Ignition 3 Con-
trol Output wire, the H4/9 wire or H7/1 wire.
5.
6.
Dual Pulse Door Unlock Output
Factory Security Disarm Signal Output
Start Status (By-pass Control) Output
H4/9 Blue/Black Wire – (-) 200mA Security Bypass Output ........... 20
GM VATS Key Override
H5 6-PIN DOOR LOCK CONNECTIONS .................................. 21-22
H6 2-PIN BLUE CONNECTOR FOR THE PROGRAM SWITCH ........ 19
PROGRAMMING ................................................................... 23-30
Programming Transmitter ......................................................... 23
Feature I Programming ........................................................ 23-24
Feature II Programming ........................................................... 25
Feature III Programming .......................................................... 26
Feature IV Programming ........................................................... 27
Engine Checking Tach/RPM Learning ...................................... 27-28
Check Level Programming ......................................................... 28
Engine Checking Voltage ........................................................... 28
Start Timer Programming ......................................................... 29
Return to Factory Default Setting .......................................... 29-30
Shutdown Diagnostics .............................................................. 30
TESTING YOUR INSTALLATION ........................................... 31-35
Caution .................................................................................. 31
Neutral Start Safety Test .......................................................... 31
Mechanical Neutral Safety Switch Considerations ......................... 32
Park/Neutral ECM Input ....................................................... 32-33
Key In Sensor Circuits .............................................................. 33
Maintaining Factory Circuits ................................................. 33-35
OWNER’S WARNING ................................................................. 36
REMOTE TRANSMITTER OPERATION .......................................... 37-39
A. Transmitter Functions .......................................................... 37
B. Lock Doors ........................................................................ 37
C. Unlock Doors ..................................................................... 37
D. Car Locator ........................................................................ 38
E. Panic Function .................................................................... 38
F. Dome Light Convenience Delay and Supervision ...................... 38
G. Ignition Controlled Door Lock and Unlock ............................... 38
H. Trunk Release (Channel 3) Output......................................... 38
I. Driver Paging ...................................................................... 38
J. Vibration/Melody Mode ......................................................... 39
K. Screen Lamp On .................................................................. 39
TABLE OF CONTENTS