5
60
routed through the Steering Column and up towards
and then around the
Ignition Key Cylinder
and
needs to be positioned so that there are at least
(2)Two turns (the more turns the better chance
the signal will be Received by the Factory Receiver
Antenna) around the Ignition Key Cylinder as shown
below.
Transponder systems often have a
BLACK PLAS-
TIC RING
around the Ignition Lock Switch. This is
the vehicle’s Transponder Pick-up or Receiver Ring
Antenna. It is important that the
at Least (2) Two
loops
of the Bypass Module’s
TRANSPONDER
LOOP ANTENNA
be mounted on or as close to
the Factory Receiver Ring (BLACK PLASTIC RING)
as possible. Slide the tube up towards the ignition
switch to tighten up the loops of wire. Tape in place
to hold. Plug the 2-Pin Connector of the Transponder
Loop Antenna into the Universal Bypass Module.
TRANSPONDER / PASSLOCK III
Now start the vehicle with the Remote Starter. If
the vehicle starts and runs for at least 30 seconds
the Transponder Bypass Module, the placement of
the Key inside the Bypass Module and the Tran-
sponder Loop Antenna are installed correct.
4.
TABLE OF CONTENTS
REMOTE START OPERATION ................................................ 39-42
A. To Remote Start Your Vehicle ........................................... 39-42
B. To Operate Your Vehicle While Running on the Remote Start ..... 40
C. Pit Stop Feature .................................................................. 40
D. Timer Start ................................................................... 40-41
E. To Turn Off the Remote Starter ............................................. 41
F. Shut Down Input for Remote Starter ...................................... 41
G. Disabling the Remote Start System ....................................... 42
LCD REMOTE TRANCEIVER ........................................................ 43
REMOTE LCD ICON DESCRIPTIONS ........................................... 43
MODEL IF114 SECURITY BYPASS MODULE .......................... 44-54
WARRANTY............................................................................... 55
REQUIRED TOOLS
Unless your remote starter includes a Bonus Installation Kit you will need
the following items: a sharp knife, electrical tape and a computer-friendly
test light. A 5/16-inch drill bit may be needed to install the hood pin switch.
If the bottom of your dash on the driver’s side will come off, you must
remove it. If this is the case a screwdriver or a wrench may be needed.
INSTALLATION CHECK LIST
• Read the manual.
• Watch the video.
• Verify that you have all the parts listed in the manual.
• Obtain the correct wiring chart for you vehicle.
• Identify air bag and SRS wires before starting your installation.
Check to see if additional parts are needed. These items are identified in
your manual and the wiring chart diagram for your vehicle.
Possible items to review:
•
Anti-theft By-pass included • Relays
• Diodes
• Transponder Key
• EZ-Bus
• Resistors
Check for optional parts to make your installation easier:
• T-harness
• EZ-Bus
Summary of Contents for DELUXE 200B
Page 1: ......
